AQVA M / 10 inchfilter package, ultra, 0,1µm

AQVA M-Size Ultrafilter Package for Lake Water Purification

The perfect water clarifier for turning lake water into usable water, such as sauna washing water. This AQVA M-size ultrafilter package, featuring a 0.1 µm membrane, effectively reduces humus, bacteria, and other microbiological impurities from utility water. Ideal for purifying water at a single water point. For drinking water purification, especially when microbiological impurities are present, we recommend a reverse osmosis system, such as the AQVA Smart EVO drinking water purifier.

Benefits:

• Enhances utility water quality

• Easy maintenance

• Pressure release button for effortless housing opening

• No drainage system required

Purification and Filtration Methods:

The ultrafilter’s 0.1 µm membrane mechanically removes microbiological impurities. For comparison, bacteria typically measure around 0.2 µm, and humus particles are approximately 0.45 mm.

Removes from Water:

• Humus

• Bacteria

• Yeasts and molds

• Cysts

• Blue-green algae (cyanobacteria)**

Note: For complete removal of cyanobacterial toxins, we recommend reverse osmosis technology, such as the AQVA Smart EVO reverse osmosis drinking water purifier.

Replacement Filter:

• Filter cartridge: AQUF01-M 

• Typical lifespan: 3,000–14,000 liters*

• *Filter lifespan depends on raw water quality. Replace the filter when water flow decreases significantly or outlet pressure drops near zero, indicating a clogged filter. If you notice changes in purified water quality, we recommend conducting a follow-up water analysis of the raw water.

Package Contents:

• Ultrafilter cartridge

• Filter housing

• Housing tightening wrench

• Wall-mount bracket

Technical Specifications:

• Compatible with standard 10-inch inline filter cartridges in the AQVA M-size filter housing

• Recommended flow rate: Approximately 5 liters per minute, suitable for 1 water point

• Pressure drop: 0.3 bar at a flow rate of approximately 10 L/min

• Membrane size: 0.1 µm

• Connection size: 3/4-inch threaded fittings

• Dimensions: Housing height 32 cm, width 13 cm; wall-mount bracket height 4 cm

• Operating temperature: 2–30°C

• Features a pressure release button for easy housing opening

• Refer to the user manual available under the “Downloads” tab

System Requirements:

• Consistent inlet pressure: 2–10 bar

• Water supply to the purifier, typically installed after a membrane pressure tank or pump

• Pre-filtration unit: Due to the ultrafilter’s tight mechanical membrane, adequate pre-filtration is essential. For example, use a fine filtration package (AQ1MC-MF1).

• Other impurities, such as iron/rust, must be removed first using an iron filter (e.g., AQ1MC-FE). Large humus quantities (>5 mg/L COD) should be pre-treated with a humus filter (e.g., AQ050X).

Winter Storage:

During winter, if temperatures drop below 2°C, close water lines and drain the inline filter housing to prevent freezing damage.